ITI trade Driver Cum Mechanic is powered by NCVT.  ITI trade Driver Cum Mechanic  is a job oriented trade ITI trade Driver Cum Mechanic is suitable for government job and private job. This ITI trade Driver Cum Mechanic is very powerful for self-empowerment. This ITI trade Driver Cum Mechanic is perfectly design to fulfill industrial requirement of Indian Industries as well as International industries.

• Driver cum Mechanic,drivesmotor car according to owner's requirement as paid employee. Observes road signals and traffic rules.
• Driver cum Mechanic repairs to motor vehicles under guidance of Mechanic Motor vehicle (MMV). Receives instructions from Mechanic, Automobile about tasks to attend. Jacks up vehicle to  equired height for repair in convenient position where necessary.
• Lubricates joints, tightens loose parts and makes necessary adjustments
• Sets wheel alignment, adjust, steering, clutch, hand brakes, brake pedal etc fits new or repaired accessories and body parts, and performs other tasks to effect repairs
• Carryout routine Maintenance of Battery and Ignition System
• Carryout Tire Maintenance
• Identify Computer Parts and operate the computer

A trainee after attending the course on ‘Driver cum Mechanic’ shall be able to drive motor car according to owner's requirement, observe road signals and traffic rules, repair motor vehicles under guidance of a Mechanic (Motor vehicle), jack up vehicle to the required height for repair in convenient position where necessary, lubricate joints, tighten loose parts and make necessary adjustments, set wheel alignment, adjust steering, clutch, hand brakes, brake pedal etc., fit new or repaired accessories and body parts, and carry out routine maintenance of battery and ignition systems, and tire. 

• Driver cum Mechanic, drives motor car according to owner's requirement as paid employee. Observes road signals and traffic rules. 
• Driver cum Mechanic repairs to motor vehicles under guidance of Mechanic Motor vehicle (MMV). Receives instructions from Mechanic, Automobile about tasks to attend.
   

ITI trade Mechanic Auto Electrical and Electronics is powered by NCVT.  ITI trade Mechanic Auto Electrical and Electronics  is a job oriented trade ITI trade Mechanic Auto Electrical and Electronics is suitable for government job and private job. This ITI trade Mechanic Auto Electrical and Electronics is very powerful for self-empowerment. This ITI trade Mechanic Auto Electrical and Electronics is perfectly design to fulfill industrial requirement of Indian Industries as well as International industries.

After successful completion of the above course, the trainee shall be able to perform the following skills with proper sequence.

Installs, repairs replaces and overhauls wiring, starters, generators, distributors and other electrical equipment of motor vehicles.

• Examines vehicle battery, checks voltage and specific gravity using special equipment such as voltmeter hydrometer, heavy discharge tester, etc. and ensures that battery is in good condition.
• Checks vehicle wiring, locates faults and rectifies defects by replacing damaged wire or connecting ends with insulation tape.
• Starts engine to check whether alternator is charging correctly, and if distributor, condenser coil and cut out are functioning properly.
• Estimates nature of defects and reports components to be replaced or repaired.
• Dismantles and repairs electrical units and components such s generator, distributor etc. where required.
• Replaces repaired kit or unit in vehicle and connects it with battery.
• Conducts thorough examination of various electrical fittings such as lights, panel indicators, fuel pumps, etc and rectifies defects.
• Checks condition and makes necessary adjustments. May do armature winding. May drive vehicles on road. May charge batteries.
• Fits, assembles and repairs various kinds of electronic equipment in factory or workshop or at place of use.
• Examines drawings and wiring diagrams; checks parts for accuracy of fit and minor adjustments; assembles parts or mounts them on chassis or panels with aid of hand tools; Installs and connects wiring, soldering joints equipment, diagnoses faults with aid of electronic testing equipment;
• Dismantles equipment if required and replaces faulty parts or wiring